Post CB Phase 2: Shipping: Will ship ASAP. Pick-up: 11am to 4pm, Monday to Friday. Walk-in purchase: Not available.
If you're unable to reach us by phone, drop us an email.

Standalone Momentary Capacitive Touch Sensor Breakout

9 pc(s)
SEN-02669

$4.50

This "momentary" capacitive touch sensor is the simplest way to add user input to a project without using a button. No microcontroller is required here - just power it with 3.3 to 5.5VDC and touch the pad to activate the sensor. The sensor-pad area is connected to a dedicated,...
+

This "momentary" capacitive touch sensor is the simplest way to add user input to a project without using a button. No microcontroller is required here - just power it with 3.3 to 5.5VDC and touch the pad to activate the sensor.

The sensor-pad area is connected to a dedicated, single-button capacitive sense chip to detect capacitive load. As long as a touch (e.g., from a finger) is detected, the output pin goes high.

Comes with a fully assembled board with 2.54mm male header.

Dimensions: 24 x 24mm

Good to know