These are sealed non-addressable 5 meters long RGB LED strips that come packed with 60 5050 LEDs per meter. Each of these strips need a 9V to 12V power supply and you can control the entire strip at once with any microcontroller and three transistors. These strips are coated with silicon but they are not designed for long term submersion in water, or exposed to UV (eg sunlight) for extended periods of time. They are for indoor use or light outdoor use without direct sun/water.
There's a adhesive strip on the back which should stick to most smooth surfaces. You can cut this stuff pretty easily with wire cutters, there are cut-lines every 5cm (3 LEDs each), and trim off the weatherproof cover with a hobby knife. Solder to the 0.1" copper pads and you're good to go.
Note: These LED strips come in 5 meters. They are preterminated with female connectors, as shown in the pictures. Check below for compatible IR and RF Remote Controllers.
- 60 LEDs per meter
- Clear weatherproof sealed
- Adhesive strip on back
- Max 1.2 Amps per meter (all LEDs lit full brightness)
- 3 common-anode RGB LEDs per segment, 20 segments per meter