On sale

1 2 3 4
Newest Items First
63 Per Page
-25%
LilyPad Slide Switch
$2.95 $3.95  
2 pc(s)
This is a simple slide switch for the LilyPad. Use it as a simple ON/OFF switch, or to control LEDs, buzzers, sensors, etc. LilyPad is a wearable e-textile technology developed by Leah Buechley and cooperatively designed by Leah and SparkFun. Each LilyPad was creatively designed to...
− +
-30%
Force Sensitive Resistor - Small (FSR400) - Male Pin Header
$6.30 $9.00  
61 pc(s)
This is a small force sensitive resistor. It has a 0.16" (4 mm) diameter active sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR,...
− +
-33%
Screw Terminals 5mm Pitch (2-Pin)
$0.50 $0.75  
53 pc(s)
Screw Terminals with 5mm pitch pins. Comes in 2 positions and have the really cool feature of slide-locking together to form any size you need (4, 6, up to 20 without problems). Rated up to 300V @ 8A. Terminal can accept 26 to 14AWG wire. 5mm/197mil pin pitch will line up well with standard...
− +
-51%
Momentary Push Button Switch - 12mm Square
$0.17 $0.35  
230 pc(s)
This is a standard 12mm square momentary button. What we really like is the large button head and good tactile feel (it 'clicks' really well). This button is great for user input on a PCB or a good, big reset button on a breadboard. Breadboard friendly!
− +
-27%
LilyPad Buzzer
$6.50 $8.85  
2 pc(s)
This is a small buzzer for the LilyPad system. Use 2 I/O pins on the LilyPad main board and create different noises based on the different frequency of I/O toggling. Loud enough to hear inside a pocket but not obtrusively loud. Please note: This is an inductive buzzer meaning that is will act...
− +
-31%
LilyPad RGB LED
$5.50 $7.95  
3 pc(s)
Blink any color you need! Use the LilyPad RGB LED board as a simple indicator, or by pulsing the red, green, and blue channels, you can produce a broad variety of colors. Each of the colors in the RGB LED are connected to one of the sew tabs on the board labeled R, G, and B. The color...
− +
-21%
LPG Gas Sensor - MQ-6
$5.95 $7.50  
1 pc(s)
This is a simple-to-use liquefied petroleum gas (LPG) sensor, suitable for sensing  LPG (composed of mostly propane and butane) concentrations in the air. The MQ-6 can detect gas concentrations anywhere from 200 to 10000ppm. This sensor has a high sensitivity and fast response...
− +
-50%
Interface Cable RP-SMA to U.FL
$3.45 $6.95  
4 pc(s)
This connector cable interfaces UFL RF connectors to RP-SMA antennas. Use it to attach any standard RP-SMA 2.4GHz antenna to the DPAC 802.11 modules. Dimensions: 4" Length
− +
-6%
RS232 Shifter SMD
$23.00 $24.50  
2 pc(s)
The smallest and easiest to use serial conversion circuit on the market! This board has one purpose in life - to convert RS232 to TTL and vice versa (TX and RX). This will allow a microcontroller to communicate with a computer. Shifter SMD is powered from the target application and can run at...
− +
-28%
Photo Interrupter GP1A57HRJ00F
$4.00 $5.55  
3 pc(s)
This sensor is composed of an infrared emitter on one upright and a shielded infrared detector on the other. By emitting a beam of infrared light from one upright to the other, the sensor can detect when an object passes between the uprights, breaking the beam. Used for many applications...
− +
-20%
XBee Explorer Serial
$26.00 $32.50  
1 pc(s)
This is a simple to use, RS232 to serial base unit for the XBee line. This unit works with all XBee modules including the Series 1 and Series 2, standard and Pro version. Plug the unit into the XBee Explorer, attach a RS232 cable, and you will have direct access to the serial and programming...
− +
-30%
SMC04 High-Power Motor Controller w/Feedback
$88.00 $125.00  
1 pc(s)
The SMC04 high-power motor controller with feedback has multiple interface and feedback options that simplify servo control of commonly available DC motors. T he module features three independent interfaces: a serial protocol for microcontroller-based applications, a pulse-width...
− +
-50%
Transceiver nRF2401A with Chip Antenna
$13.25 $26.50  
3 pc(s)
This nRF2401A module has the same minimum interface of 7 pins (all in a .1" spaced connector) as the original nRF2401A module, but the size is reduce by over 60%! These are the nRF2401A 2.4GHz transceiver modules with built in chip antenna designed around the Nordic Semiconductor nRF2401A...
− +
-50%
Standard LCD 16x2 - White on Blue 5V
$2.90 $5.80  
403 pc(s)
This is a standard 16 character by 2 line display. White text on Blue background. Utilizes the extremely common HD44780 parallel interface chipset ( datasheet ). Interface code is freely available. You will need ~11 general I/O pins to interface to this LCD screen. Features :...
− +
-7%
RS232 Shifter SMD Without DB9
$15.75 $17.00  
5 pc(s)
The smallest and easiest to use serial conversion circuit on the market! This board has one purpose in life - to convert RS232 to TTL and vice versa (TX and RX). This will allow a microcontroller to communicate with a computer. Shifter SMD is powered from the target application and can run at...
− +
-20%
TEMT6000 Breakout Board
$6.00 $7.50  
3 pc(s)
Basic breakout board for the TEMT6000 Ambient Light Sensor. Only what you need, nothing you don't. Sensor acts like a transistor - the greater the incoming light, the higher the analog voltage on the signal pin. Documents: Datasheet Wiring Example...
− +
-50%
Transceiver nRF24L01+ Module with Chip Antenna
$15.00 $30.00  
1 pc(s)
This module uses the newest 2.4GHz transceiver from Nordic Semiconductor, the nRF24L01. This transceiver IC operates in the 2.4GHz band and has many new features! Take all the coolness of the nRF2401A and add some extra pipelines, buffers, and an auto-retransmit feature - very nice!...
− +
-15%
PIR Motion Sensor
$13.20 $15.50  
5 pc(s)
This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the 'alarm' pin will go low. Red wire is power (5 to 12V). White wire is GND. Black wire is open collector Alarm....
− +
-32%
Reed Switch
$2.00 $2.95  
Out-of-stock
This is a small device called a reed switch . When the device is exposed to a magnetic field, the two ferrous materials inside the switch pull together and the switch closes. When the magnetic field is removed, the reeds separate and the switch opens. This makes for a great...
Out-of-stock
-36%
Quad-band Cellular Duck Antenna SMA
$8.00 $12.55  
2 pc(s)
This is a small, high-quality, quad-band, regular SMA terminated, cellular antenna. Specifications: GSM/850E : 824 to 894MHz GSM : 880 to 960MHz DCS : 1710 to 1880MHz PCS : 1850 to 1990MHz Documents: GSM Antenna 850-1900MHz
− +
-20%
Sabertooth 2x25A 6V-24V Regenerative Motor Driver (v2)
$188.00 $235.00  
2 pc(s)
The Sabertooth 2X25 is one of the most versatile, efficient and easy to use dual motor drivers on the market. It is suitable for high powered robots - up to 100lbs in combat or 300lbs for general purpose robotics. Out of the box, the Sabertooth can supply two DC brushed motors with up...
− +
-50%
SSOP to DIP Adapter 8-Pin
$2.50 $5.00  
6 pc(s)
8, 16, 20, and 28-Pin SSOP to DIP break out boards. The footprint was rotated to accommodate different width SSOP devices and can be used with any pin count up to 28 pins. Designed to be used with 0.65mm pitch devices but can also be used with 0.025" pitch devices (comes out to ~0.635mm)....
− +
-50%
SOIC to DIP Adapter 28-Pin
$3.15 $6.30  
22 pc(s)
Low-cost basic SOIC break out boards. These are custom PCB boards that interface standard SOIC devices to standard .1" (2.54mm) headers. 28-SOIC: Standard .6" spacing between pins. Will fit directly into a standard width (600 mil) DIP socket. For wide ICs (memories, drivers, 74s,...
− +
-50%
SSOP to DIP Adapter 20-Pin
$1.95 $3.90  
5 pc(s)
8, 16, 20, and 28-Pin SSOP to DIP break out boards. The footprint was rotated to accommodate different width SSOP devices and can be used with any pin count up to 28 pins. Designed to be used with 0.65mm pitch devices but can also be used with 0.025" pitch devices (comes out to ~0.635mm)....
− +
-50%
SSOP to DIP Adapter 28-Pin
$3.15 $6.30  
14 pc(s)
8, 16, 20, and 28-Pin SSOP to DIP break out boards. The footprint was rotated to accommodate different width SSOP devices and can be used with any pin count up to 28 pins. Designed to be used with 0.65mm pitch devices but can also be used with 0.025" pitch devices (comes out to ~0.635mm)....
− +
-50%
2mm 10pin XBee Socket
$0.50 $1.00  
100 pc(s)
This is a 10-pin socket with 2mm pitch that mates with the popular XBee radio from Maxstream. Use this small part to avoid having to solder your precious radio to a PCB. You'll need two of these sockets to connect to all 20 pins on the XBee. Sold in single unit.
− +
-50%
Mini Push Button Switch
$0.10 $0.20  
1043 pc(s)
Miniature Single Pole Single Throw switches. These are high quality momentary on switches. Perfect as a tactile reset switch. Mounts directly into standard bread boards. Rated up to 50mA. Documents : Datasheet (TSS-TC-0104)
− +
-50%
Single Row Break Away Female Header
$0.75 $1.50  
273 pc(s)
Single row of 40-holes, female header. Can be cut to size with a pair of wire-cutters. Standard .1" spacing. We use them extensively in the Olimex development boards. They mate very well with break away headers. Please note: You will probably lose one pin with each cut....
− +
-50%
Single Row Break Away Pin Header - Straight (Black)
$0.75 $1.50  
119 pc(s)
A row of headers - break to fit. 40 pins that can be cut to any size. Used with custom PCBs or general custom headers. Features: Pin Style: Square Number of Pins: 40 Pin Spacing: 0.1" (2.54 mm) Pin Length: 11.5 mm
− +
1 2 3 4