Delivery fee

New items

1 2 3 4 5 6 7 8 9 10 11 12
6 - 20
Sort Alphabetically: Z to A
24 Per Page
Thermoelectric Cooler - 40x40mm
$3.90  
3 pc(s)
Thermoelectric coolers (TEC or Peltier) create a temperature differential on each side. One side gets hot and the other side gets cool. Therefore, they can be used to either warm something up or cool something down, depending on which side you use. The Thermal Tape listed below works very...
− +
-26%
Thermistor 10K
$1.00 $1.35  
11 pc(s)
10K thermistor with a negative temperature coefficient. Good choice for temp-sensing aplications. Vishay part #: NTCLE100E3103JB0 Note: You get only one thermistor. Document: Datasheet
− +
-50%
Thermally Conductive Adhesive
$0.75 $1.50  
20 pc(s)
This thermally conductive adhesive is used widely for heat sinks without fixed fastener, such as on voltage regulator, MOSFET, high power LED and so on. It allows heat to be transferred from IC to the heat sinks, effectively protects IC from thermal impacts, Features : Heat conductivity:...
− +
-20%
TEMT6000 Breakout Board
$6.00 $7.50  
3 pc(s)
Basic breakout board for the TEMT6000 Ambient Light Sensor. Only what you need, nothing you don't. Sensor acts like a transistor - the greater the incoming light, the higher the analog voltage on the signal pin. Documents: Datasheet Wiring Example...
− +
Temperature Sensor - Waterproof (DS18B20) w/Male Pin Header
$9.90  
5 pc(s)
This sealed digital temperature probe lets you precisely measure temperatures in wet environments with a simple 1-Wire interface. The DS18B20 provides 9 to 12-bit (configurable) temperature readings over a 1-Wire interface, so that only one wire (and ground) needs to be connected from a...
− +
Temperature Sensor - Waterproof (DS18B20) w/Interface Board
$12.90  
7 pc(s)
This sealed digital temperature probe lets you precisely measure temperatures in wet environments with a simple 1-Wire interface. The DS18B20 provides 9 to 12-bit (configurable) temperature readings over a 1-Wire interface, so that only one wire (and ground) needs to be connected from a...
− +
Temperature Sensor - TMP36
$2.90  
375 pc(s)
The TMP36 are low voltage, precision centigrade temperature sensors. They provide a voltage output that is linearly proportional to the Celsius (centigrade) temperature. The TMP36 do not require any external calibration to provide typical accuracies of ±1°C at +25°C and ±2°C over the −40°C...
− +
-50%
Teensy SmartMatrix Shield Kit for RGB LED Panel
$12.45 $24.90  
12 pc(s)
The SmartMatrix Shield is the best way to connect the Teensy 3.2 to Large RGB LED matrix display panels . The shield makes it easy to connect the 13 signals required to drive the display, connects an external 5V supply to power the display and Teensy, and brings out the Teensy's free...
− +
Teensy 4.0 - Headers (USA)
$42.90  
4 pc(s)
Teensy 4.0 is the latest Teensy, offering the fastest microcontroller and powerful peripherals in the Teensy 1.4 by 0.7 inch form factor. It features an ARM Cortex-M7 processor at 600MHz, with a NXP iMXRT1062 chip, the fastest microcontroller available today. Teensy 4.0 is the same size and...
− +
-29%
Tactile Button Assortment Pack of 12
$6.50 $9.10  
19 pc(s)
These tactile buttons are great for all sorts of projects. This assortment comes with 2 of each of 6 different colors for a total of 12 buttons. The colored caps are removable and the buttons fit into breadboards. See the drawing below for exact dimensions. Documents: Drawing
− +
T5577 RFID Tag - Read/Write 125kHz
$2.95  
8 pc(s)
RFID is useful for sensing and identifying tagged people and objects for access control, automation, and a whole range of different applications. This basic T5577 RFID tag works in the 125kHz RF range and supports read/write operation. Note : This is a blank tag - its ID must be chosen and...
− +
T-Slot Nuts For MakerBeamXL (50pcs)
$17.50  
8 pc(s)
The MakerBeamXL T-slot nut is made of stainless steel and was specially designed to slide into the T-slot grooves of the MakerBeamXL profile. The T-slot nut is great to fasten brackets or corner cubes.
− +
-50%
T-Expansion Board For Micro:Bit
$4.45 $8.90  
202 pc(s)
This T-Expansion For Micro:Bit is a small board that connects to the BBC micro:bit and breaks out all 19 GPIO, power and ground pin to breadboard-friendly arrangement and spacing. This board has all the pins labeled nicely so you can go forth and build circuits without keeping a pin-out...
− +
T-Bracket For MakerBeamXL (12 pcs)
$15.50  
10 pc(s)
The stainless steel T-bracket is a great addition to MakerBeamXL product range. It is compatible with both threaded and non-threaded MakerBeam. Includes 12x Stainless steel T-Bracket for MakerBeamXL
− +
-50%
Swivel Caster Wheel
$0.75 $1.50  
57 pc(s)
This Swivel Caster Wheel is perfect for use with 2-wheeled robots that need a third-point of support. The nylon wheel comes attached to a metal plate and with M4 screw holes for fastening to any robot or project. It can rotate a full 360° on the plate and the sleek silver metal look suits any...
− +
SWADJHV High Voltage Step Down Adjustable Switching Regulator
$42.50  
4 pc(s)
The SWADJHV is the a high-voltage edition of our popular DE-SWADJ adjustable switching reulators. It is designed to accept an input voltage ranging from 5-60V, allowing you to power a variety of applications from extremely high-voltage sources. The SWADJHV is pin-compatible with the common 78XX...
− +
Super Bright LED - Yellow 5mm (10 pcs)
$0.95  
127 pc(s)
These are very bright LEDs. The LEDs are so bright that it hurts to look directly at them. All lenses are clear. Features: Standard size - T1 3/4 5mm 7,000mcd brightness 2.0V forward drop Forward current 20mA Documents:...
− +
Super Bright LED - White 10mm (5 pcs)
$0.95  
20 pc(s)
Huge 10mm through hole LEDs. The LEDs are so bright that it hurts to look directly at them. All lenses are clear. Pack of 5 LEDs. Features : 3.0-3.4VDC Forward Voltage 80mA Forward Current 30 degree viewing angle 16,000-20,000 MCD output
− +
Super Bright LED - Red 5mm (10 pcs)
$0.95  
6 pc(s)
These are very bright LEDs. The LEDs are so bright that it hurts to look directly at them. All lenses are clear. Features: Standard size - T1 3/4 5mm 8,000mcd brightness 2.0V forward drop Forward current 20mA Documents:...
− +
Super Bright LED - Green 5mm (10 pcs)
$0.95  
51 pc(s)
These are very bright LEDs. The LEDs are so bright that it hurts to look directly at them. All lenses are clear. Features: Standard size - T1 3/4 5mm 18,000mcd brightness 3.2V forward drop Forward current 20mA Documents:...
− +
Super Bright LED - Blue 5mm (10 pcs)
$0.95  
2 pc(s)
These are very bright LEDs. The LEDs are so bright that it hurts to look directly at them. All lenses are clear. Features: Standard size - T1 3/4 5mm 6,000mcd brightness 3.2V forward drop Forward current 20mA Documents:...
− +
Super Bright LED - Blue 10mm (5 pcs)
$0.95  
30 pc(s)
Huge 10mm through hole LEDs. The LEDs are so bright that it hurts to look directly at them. All lenses are clear. Pack of 5 LEDs. Features : 465-470nm Blue 3.0-3.4VDC Forward Voltage 80mA Forward Current 30 degree viewing angle 8,000-10,000 MCD output...
− +
Super Bright LED - White 5mm (10 pcs)
$0.95  
54 pc(s)
These are very bright LEDs. The LEDs are so bright that it hurts to look directly at them. All lenses are clear. Features: Standard size - T1 3/4 5mm 22,000mcd brightness 3.2V forward drop Forward current 20mA View angle 15 Deg...
− +
Sunflower Solar Power Manager 5V
$14.50  
2 pc(s)
Solar Power Manager 5V is a small power and high-efficiency solar power management module designed for 5V solar panel. It features as MPPT (Maximum Power Point Tracking) function, maximizing the efficiency of the solar panel. Apart from serving as a solar charger, the module can provide up to...
− +
1 2 3 4 5 6 7 8 9 10 11 12
6 - 20