Delivery fee

New items

1 2 3 4 5 6 7 8
2 - 16
$31.95 $39.90  
2 pc(s)
The ZX Distance and Gesture Sensor is a touchless sensor that is capable of looking for simple gestures. Developed in conjunction with XYZ Interactive , the sensor uses their GestureSense® technology to recognize the distance of an object away from the sensor up to about 12 inches (30cm,...

$189.95  
Out-of-stock
The Zumo robot is a low-profile tracked robot platform intended for use with an Arduino (or compatible device) as its main controller. It measures less than 10 cm on each side and weighs approximately 300 g with an Arduino Uno and batteries (165 g without, as shipped), so it is both small...
Out-of-stock

$155.00  
Out-of-stock
IMPORTANT: This version (X4), with maximum laser power of 5mW, is a class 3a laser apparatus and does not require license to possess or use. The YDLIDAR X4 360° Laser Scanner is the low cost 360 degree two-dimensional LiDAR. This product can perform 360 degree scan within 10-meter...
Out-of-stock

$26.00 $32.50  
1 pc(s)
This is a simple to use, RS232 to serial base unit for the XBee line. This unit works with all XBee modules including the Series 1 and Series 2, standard and Pro version. Plug the unit into the XBee Explorer, attach a RS232 cable, and you will have direct access to the serial and programming...

$12.99  
6 pc(s)
This is the RGB LED matrix panel with 64 WS2812B LEDs arranged in an 8x8 matrix. Each LED is capable of drawing as much as 60mA (at peak brightness the matrix can draw just over 3.5 Amps at 5 Volts), this adds up so it is suggested to use a 5V 2A power supply. For most uses, you'll see about...

$5.25 $7.50  
130 pc(s)
Round and round and round they go! 24 ultra bright smart RGB LED are arranged in a circle with 86mm outer diameter. The rings are 'chainable' - connect the output pin (DO) of one to the input pin (DI) of another. Use only one microcontroller pin to control as many as you can chain together!...

$2.80  
12 pc(s)
This is the WS2812 Addressable RGB LED Stick with eight LEDs. The WS2812 is a addressable smart RGB LED that uses a single data line to control brightness and colour. The embedded constant-current driver keeps the LED brightness consistent even if the input voltage varies. There are...

$2.50  
1 pc(s)
This is the WS2812 Addressable RGB LED Stick with eight LEDs. The WS2812 is a addressable smart RGB LED that uses a single data line to control brightness and color. The embedded constant-currnet driver keeps the LED brightness consistent even if the input voltage varies. There are...

$1.00  
7 pc(s)
We know this looks like a lot of our other LEDs, but it's not! This is a PTH Addressable RGB LED with a WS2812 control IC built right into the LED. This PTH version is incredibly similar to its SMD cousin, except it is breadboard friendly and a lot simpler to solder into your project and is...

$1.00  
27 pc(s)
We know this looks like a lot of our other LEDs, but it's not! This is a PTH Addressable RGB LED with a WS2812 control IC built right into the LED. This PTH version is incredibly similar to its SMD cousin, except it is breadboard friendly and a lot simpler to solder into your project and is...

$9.90  
10 pc(s)
These are good quality 6" wire strippers with 6 gauge settings. We really wanted to stock these because they strip 30AWG wire wrap wire nicely as well as the standard 22AWG hook up wire. Features: 30, 28, 26, 24, 22, 20 AWG settings 0.25, 0.32, 0.4, 0.5, 0.6, 0.8 mm...

$5.00  
6 pc(s)
Stranded core wires with male connectors on both ends. Use these to jumper from any female header on any board, to any other female header. Approx. 100pcs. 8cm Length.

$6.95  
5 pc(s)
This Wind Power Kit is designed to show students how alternative energy is created by harnessing the power produced by the wind. The kit has a high efficient generator that can produce useful electricity at low speed. It can generate sufficient electricity to light up a LED by blowing onto the...

$7.45  
7 pc(s)
This Wind Power Kit is designed to show students how alternative energy is created by harnessing the power produced by the wind. The kit has a high efficient generator that can produce useful electricity at low speed. It can generate sufficient electricity to light up a LED by blowing onto the...

$7.95 $9.95  
56 pc(s)
The ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol stack that can give any microcontroller access to your WiFi network. The ESP8266 is capable of either hosting an application or offloading all Wi-Fi networking functions from another application processor. Each...

$26.70  
6 pc(s)
This Wide Angle Ambient Light Sensor is based on BH1750 - a digital ambient light sensor with a 16 bit AD converter built-in which can directly output a digital value in lux (Lx) over a range of 1 - 65535 lx. This sensor is far more accurate and easier to use as compare to photocell which...

$0.45  
4 pc(s)
This custom-designed plastic wheel has a rubber ring measuring 44mm in diameter and is designed to fit the 2mm shafts and the output shaft on our DC toy motor . It also has a slot for fitting onto our TT motor and comes with a mounting screw for secure attachment. Wheel body: ø44 x 7mm

$0.45  
41 pc(s)
This custom-designed plastic wheel has a rubber ring measuring 32mm in diameter and is designed to fit the 2mm shafts and the output shaft on our DC toy motor . It also has a slot for fitting onto our TT motor and comes with a mounting screw for secure attachment. Wheel body: ø32 x 7mm

$2.00  
6 pc(s)
This wheel is designed specifically for our Micro Servo 9g - Full Rotation. It comes with a rubber tread, and a press-fit design to make connecting super quick and easy. Note: Wheel only. Servo not included. Wheel body: 56 x 8mm

$2.95  
4 pc(s)
This wheel is designed specifically for our 5V stepper motor It comes with a rubber tread, and a press-fit design to make connecting super quick and easy. Note: Wheel only. Stepper motor not included. Wheel body: 56 x 8mm

$9.95 $19.95  
10 pc(s)
The simple encoder kit from consists of two neodymium 8-pole magnets with rubber hubs and two hall-effect sensors terminated with 150mm (6inch) cable and 3 pin female servo headers. The magnets have 4 north poles and 4 south poles and are strong enough that the sensor can detect the poles from...

$2.10  
4 pc(s)
This Water Sensor is designed for water detection, which can be used in sensing the water level and leakage. This sensor works by having a series of exposed copper traces which will turn on the transistor when water droplets shot the copper traces. This sensor works with the digital I/O...

$2.50  
2 pc(s)
This water sensor is designed to detect water, which can be used to sense water level and leakage. It works by using exposed copper traces to detect the presence of water droplets. The sensor board has a sensing area of 47 x 36mm. The on-board potentiometer is used to set the threshold for...

$1.95  
13 pc(s)
The W25Q64JV (64M-bit) Serial Flash memory provides a storage solution for systems with limited space, pins and power. They are ideal for storing voice, text and data. The device operates on 2.7V to 3.6V power supply with current consumption as low as 1µA for power-down. The W25Q64JV array...
1 2 3 4 5 6 7 8
2 - 16