Delivery fee

New items

1 2 3 4 5 6 7 8 9 10 11 12 13
7 - 21
Sort by Price: High to Low
24 Per Page
MakerBeam Square Headed Bolts w/ Hex Hole - M3x6
$24.90  
6 pc(s)
1 bag of approximately 250 pcs of stainless steel M3 bolts with square head and hex hole. Length: 6mm.
− +
MakerBeam Corner Cube Kit - Clear
$24.75  
23 pc(s)
The corner cubes are designed especially for makerbeams with threaded beam ends. The bag contains: 12x Aluminum corner cubes 50x Stainless steel countersunk bolts with flat head (M3 x 6) 1x Allen key Note : Not compatible with non-threaded MakerBeam.
− +
DE-SWADJ Step Down Adjustable Switching Regulator - 10W
$24.50  
2 pc(s)
The DE-SWADJ is the adjustable version of our SW0XX step down voltage regulators. It is designed to be the easiest possible way to add an adjustable voltage source to a new or existing project with all the efficiency benefits of switch-mode power. The DE-SWADJ is pin-compatible with the...
− +
-11%
FTDI Basic Breakout - 3.3V
$23.95 $26.85  
3 pc(s)
This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 3.3V Arduino boards. It can also be used for general serial applications. The major difference with this board is that it brings out...
− +
Motor Driver Board v2 for the BBC micro:bit
$23.90  
7 pc(s)
This board provides a simple way to add motor driving capability to a BBC micro:bit. It allows two motors to be driven with full forward, reverse & stop control. It has terminal blocks to connect four input devices and a regulated 3V supply is fed in to the 80 way connector to power the...
− +
SRF02 Low Cost Single Transducer Ultrasonic Range Finder
$23.80  
Out-of-stock
The SRF02 is a single transducer ultrasonic rangefinder in a small footprint PCB. It features both I2C and a Serial interfaces. The serial interface is a standard TTL level UART format at 9600 baud,1 start, 2 stop and no parity bits, and may be connected directly to the serial ports on...
Out-of-stock
BH1750 Ambient Light Sensor Breakout
$23.70  
5 pc(s)
BH1750FVI is an digital Ambient Light Sensor IC for I2C bus interface. This IC is the most suitable to obtain the ambient light data for adjusting LCD and Keypad backlight power of Mobile phone. It is possible to detect wide range at High resolution. Features I2C bus...
− +
ESP32 Development Board U.FL w/Antenna
$23.50  
14 pc(s)
The ESP32 Development Board is a low-footprint, minimal system development board powered by ESP-WROOM-32 module. The ESP-WROOM-32 is a powerful and compact module that combines Wi-Fi and Bluetooth to support a wide range of applications that require wireless and internet connectivity. This...
− +
RGB and Gesture Sensor - APDS-9960
$23.00  
2 pc(s)
This is the SparkFun RGB and Gesture Sensor, a small breakout board with a built in APDS-9960 sensor that offers ambient light and color measuring, proximity detection, and touchless gesture sensing. With this RGB and Gesture Sensor you will be able to control a computer, microcontroller,...
− +
-6%
RS232 Shifter SMD
$23.00 $24.50  
2 pc(s)
The smallest and easiest to use serial conversion circuit on the market! This board has one purpose in life - to convert RS232 to TTL and vice versa (TX and RX). This will allow a microcontroller to communicate with a computer. Shifter SMD is powered from the target application and can run at...
− +
Opto-Isolated Relay Module - 16 Channels (5V)
$22.99  
1 pc(s)
This 16 channels Relay Module can be used to control the lighting, electrical and other equipments through the digital IO port. The digital input circuit is optically isolated from the relay, so your controller is protected from voltage spikes and surges. The module is controlled with 5V...
− +
-8%
LilyPad Arduino 328 Main Board
$22.95 $24.95  
1 pc(s)
The LilyPad Arduino 328 Main Board is an Arduino-programmed microcontroller designed to be easily integrated into e-textiles and wearable projects. It offers the same functionality you find in other Arduino boards, in a lightweight, round package designed to minimize snagging and profile,...
− +
-40%
Serial Enabled 20x4 LCD - Black on Green 5V
$22.75 $37.85  
1 pc(s)
The serial enabled LCD allows you to control a parallel based LCD over a single-wire serial interface. Included in this product is a black on green 20x4 LCD connected to our serial backpack. The backpack, based around a PIC16F88, takes a TTL serial input and prints the characters it receives...
− +
VL53L0X Time-of-Flight Distance Sensor Carrier with Voltage Regulator, 200cm Max
$22.50  
5 pc(s)
The VL53L0X from ST Microelectronics is a time-of-flight ranging system integrated into a compact module. This board is a carrier for the VL53L0X, so we recommend careful reading of the VL53L0X datasheet (1MB pdf) before using this product. The VL53L0 uses ST's FlightSense...
− +
Ultrasonic Sensor with Waterproof Probe
$22.50  
6 pc(s)
Most ultrasonic distance sensors aren't waterproof which can be a problem if you need your project to withstand the elements outdoors. No need to worry any more! The probe of this sensor is waterproof and is suitable for outdoor applications such as car reversing sensors, security alarms,...
− +
-50%
SparkFun moto:bit
$22.50 $45.00  
4 pc(s)
The SparkFun moto:bit is a fully loaded "carrier" board for the micro:bit that, when combined with the micro:bit, provides you with a fully functional robotics platform. The moto:bit offers a simple, beginner-friendly robotics controller capable of operating a basic robotics chassis. Onboard...
− +
-20%
Jumper Wires Premium 6" F/F Pack (Approx. 100pcs)
$22.40 $28.00  
13 pc(s)
These are 6" long jumper wires terminated as female to female. Use these to jumper from any male header on any board. Multiple jumpers can be connected next to one another on a 0.1" header. Approx. 100 pcs per pack
− +
MakerBeam Corner Cube Kit - Black
$21.50  
2 pc(s)
The corner cubes are designed especially for makerbeams with threaded beam ends. The bag contains: 12x Aluminum corner cubes 50x Stainless steel countersunk bolts with flat head (M3 x 6) 1x Allen key Note : Not compatible with non-threaded MakerBeam.
− +
micro:bit EduFun Mini Project Kit - Automated Plant Watering System
$21.00  
3 pc(s)
SGBotic has created a series of Micro:Bit EduFun Mini Project Kits with an aim of making advance devices available to micro:bit inventors. Much efforts have been devoted to designing the MakeCode block packages to remove the complexity of using these devices, making it easier for inventors to...
− +
Analog TDS (Total dissolved solids) Sensor Kit
$20.95  
3 pc(s)
This is an Arduino-compatible TDS Sensor Kit for measuring Total dissolved solids value of the water. TDS indicates how many milligrams of soluble solids dissolved in one litre of water. In general, the higher the TDS value, the more soluble solids dissolved in water, and the less clean the...
− +
Low Profile Aluminum Case For Raspberry Pi 4
$19.99  
7 pc(s)
Raspberry Pi is everybody's favorite little computer; the last thing you want is something bad happens to it. Why not protect it with an aluminum case? This elegantly crafted Raspberry Pi 4 case is designed for the perfect combination of durability, affordability, and strength. The case...
− +
ESP32 Development Board
$19.95  
2 pc(s)
The ESP32 Development Board is a low-footprint, minimal system development board powered by ESP-WROOM-32 module. The ESP-WROOM-32 is a powerful and compact module that combines Wi-Fi and Bluetooth to support a wide range of applications that require wireless and internet connectivity. This...
− +
-20%
Sparkfun XBee Wireless Shield
$19.95 $24.95  
1 pc(s)
Xbee radios are an awesome way to add wireless capability to your Arduino project and now it's even easier with the XBee Shield. The shield form-factor mates directly with any dev board that has an Arduino standard footprint and equips it with wireless communication capabilities using the...
− +
SGBotic Micro:bit Robot Board
$19.95  
7 pc(s)
SGBotic Micro:bit Robot Board is designed for development of an autonomous obstacle avoidance robot or line following robot using BBC micro:bit . This Robot Board is capable of driving two DC motors. It has a dedicated port for HC-SR04 Ultrasonic Sensor and Line Follower Array . The...
− +
1 2 3 4 5 6 7 8 9 10 11 12 13
7 - 21