Delivery fee

New items

1 2 3 4 5 6 7 8 9
3 - 17
$37.50  
8 pc(s)
Looking for a device that allows you to control your robot and at the same time to see what the robot sees on your mobile phone? Look no further than this vRTCam from SGBotic. The vRTCam is designed for use with a mobile phone as remote controller with minimum setup. It is unique in a...

$2.75  
20 pc(s)
This is the basic LD1117V33 voltage regulator, a low drop positive regulator with a 3.3V fixed output voltage. This fixed regulator provides a great amount of stability and protection for your project and with its on chip trimming this regulator is able to reach an output voltage tolerance...

$18.95  
2 pc(s)
This sensor is a carrier/breakout board for ST's VL6180X proximity and ambient light sensor, which measures the range to a target object up to 20 cm away (or 60 cm with reduced resolution ). The VL6180X uses time-of-flight measurements of infrared pulses for ranging, allowing it to give...

$9.90  
2 pc(s)
This sensor is a breakout board for ST's VL6180X proximity and ambient light sensor, which measures the range to a target object up to 20 cm away (or 60 cm with reduced resolution). The VL6180X uses time-of-flight measurements of infrared pulses for ranging, allowing it to give accurate results...

$22.50  
5 pc(s)
The VL53L0X from ST Microelectronics is a time-of-flight ranging system integrated into a compact module. This board is a carrier for the VL53L0X, so we recommend careful reading of the VL53L0X datasheet (1MB pdf) before using this product. The VL53L0 uses ST's FlightSense...

$9.90  
5 pc(s)
The VL53L0X from ST Microelectronics is a time-of-flight ranging system integrated into a compact module. The sensor contains a very tiny invisible IR source, and a matching detector. It measures how long it takes for emitted pulses of infrared laser light to reach the nearest object and be...

$5.20  
7 pc(s)
End caps for MakerBeam in 15x15mm profile black vinyl. We finally can give our beams little feet. This specially desinged end caps will help to protect your desktop or to prevent your MakerBeam project from slipping away. It also reduces vibrations for your construction. They...

$3.90  
6 pc(s)
End caps for MakerBeam in 10x10mm profile black vinyl. We finally can give our beams little feet. This specially desinged end caps will help to protect your desktop or to prevent your MakerBeam project from slipping away. It also reduces vibrations for your construction. They...

$3.25  
16 pc(s)
This small vibratory motor module is perfect for non-audible indicators. Use in any number of applications to indicate to the wearer when a status has changed. The on-board MOSFET driver allows the module to interface directly to microcontroller. Features : Operating voltage:...

$3.95 $5.90  
4 pc(s)
This tiny DC motor produces vibrations by spinning an eccentric shaft at over 10,000 RPM when powered at 3 V. Motors like this are commonly found in cell phones and other devices that use vibration for tactile feedback, and its small size (11.6 × 4.6 × 4.8 mm) and light weight (0.8 g) make it...

$2.00 $2.50  
46 pc(s)
This itty-bitty, shaftless vibratory motor is perfect for non-audible indicators. Use in any number of applications to indicate to the wearer when a status has changed. All moving parts are protected within the housing. With a 2.6-3.6V operating range, these units shake crazily at 3V. Once...

$2.95  
45 pc(s)
These LEDs emit UV 'blacklight' in the UV spectrum so they are great for projects with fluorescent materials referred to as UV/blacklight-reactive or 'glow-in-the dark'. They are bright (350mcd) and have about a 20-degree LED beam. They go easily into a breadboard and come in a pack of ten so...

$45.00  
Out-of-stock
The USB-ISS Multifunction USB Communications Module provides a complete interface between your PC and the I2C bus, SPI bus, a Serial port and general purpose Analogue Input or Digital I/O. The module is powered from the USB. Operating voltage is selectable between 3.3V and 5V and...
Out-of-stock

$50.00 $175.00  
2 pc(s)
Got weather? This board can handle it. The USB Weather Board includes onboard sensors for barometric pressure, humidity, temperature, and light level. We've also added headers in the new version so you can connect the board to the weather meters (not included), adding sensors for wind...

$4.95  
16 pc(s)
This USB to Type-C Cable with switch is 1.5 meter long and is the perfect hard on/off power switch for your Raspberry Pi 4 or any devices that has a Type-C port. Note : The data lines are not connected, so it's mostly just good for powering and charging devices. Dimensions:...

$6.50 $6.95  
1 pc(s)
This simple board breaks out a female USB type A connector's VCC, GND, D- and D+ pins to a 0.1" pitch header. If you want to add a USB to your project, but don't want to put up with soldering tiny connectors, this is the board for you. Dimensions : 1.02 x 0.9" (26.06 x 22.93mm)...

$3.00  
3 pc(s)
This is the standard A-miniB USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your USB Hubs, FTDI Breakout Board and USB Lipo charger w/Mini B connector, among other things. Dimensions: 50cm

$2.50  
4 pc(s)
This is the standard A-miniB USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your USB Hubs, FTDI Breakout Board and USB Lipo charger w/Mini B connector, among other things. Dimensions: 30cm

$2.25 $4.50  
53 pc(s)
This is the standard A-miniB USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your USB Hubs, FTDI Breakout Board and USB Lipo charger w/Mini B connector, among other things. The Ferrite Bead helps to eleminate EMI. Dimensions: 1.5 meter

$3.95  
7 pc(s)
This is the standard A-miniB USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your USB Hubs, FTDI Breakout Board and USB Lipo charger w/Mini B connector, among other things. Dimensions: 1 meter

$3.00  
Out-of-stock
USB 2.0 type A to micro USB 5-pin. This is a new, smaller connector for USB devices. Micro USB connectors are about half the height of mini USB. Micro USB is found on newer hand held devices like cell phones and portable media devices. Connector shape may vary slightly from image as our stock...
Out-of-stock

$2.50  
1 pc(s)
USB 2.0 type A to micro USB 5-pin. This is a new, smaller connector for USB devices. Micro USB connectors are about half the height of mini USB. Micro USB is found on newer hand held devices like cell phones and portable media devices. Connector shape may vary slightly from image as our stock...

$3.00 $5.00  
1158 pc(s)
USB 2.0 type A to micro USB 5-pin. This is a new, smaller connector for USB devices. Micro USB connectors are about half the height of mini USB. Micro USB is found on newer hand held devices like cell phones and portable media devices. Connector shape may vary slightly from image as our stock...

$1.80  
3 pc(s)
USB Type-C is the latest industry-standard connector for transmitting data and power. This adapter let you attach a USB micro-B cable to a Type-C port. It is suitable for both data transfer and charging.
1 2 3 4 5 6 7 8 9
3 - 17