Delivery fee

New items

5 - 19
13 14 15 16 17 18 19 20 21 22 23 24 25 26 27
21 - 35
Newest Items First
12 Per Page
Round Shape 2 x CR2032 Coin Cell Battery Holder - 6V output with On/Off switch
$0.65  
7 pc(s)
This tiny coin cell battery holder is ideal for small portable or wearable projects. It holds two 20mm CR2032 coin cells in series to generate 6V nominal. CR2032 tends to have about 220mAh capacity so this holder would give you 6V @ 220mAh with two cells.
− +
Infrared Remote Control (21 Buttons)
$1.50  
10 pc(s)
Have you ever needed a cheap way to activate something from across the room? Infrared remotes are still the cheapest way to wirelessly control a device. This 21 buttons remote controller works with TSOP38238 infrared receiver which have an operating voltage from 2.5V - 5.5V. Includes :...
− +
Transparent Base Kit For Raspberry Pi
$3.90  
16 pc(s)
This is an acrylic base plate that can hold your Raspberry Pi and self-adhesive breadboard. The kit includes screws, washers and other accessories. Dimensions : 150mm x 100mm x 3mm
− +
SRF05 Low Cost Ultrasonic Range Finder w/Header
$28.90  
2 pc(s)
The SRF05 is an evolutionary step from the SRF04, and has been designed to increase flexibility, increase range, and to reduce costs still further. As such, the SRF05 is fully compatible with the SRF04. Range is increased from 3 meters to 4 meters. A new operating mode (tying the mode...
− +
-50%
ubit:connect Interfacing Board for BBC micro:bit - Assembled
$16.75 $33.50  
116 pc(s)
This ubit:connect Interfacing Board is specially designed for BBC micro:bit developer. It offers an easy way to connect sensors, actuators and other circuits to the micro:bit. The board comes with an 0.91" OLED display. Together with SGBotic's customised makecode package, this OLED display...
− +
micro:bit Flex Sensor
$32.50  
4 pc(s)
This micro:bit Flex Sensor is specifically designed for micro:bit to detect flexing or bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface. This sensors are easy to use. It will vary its resistance depending on how much it...
− +
-23%
Air Quality Breakout - CCS811
$29.90 $38.90  
2 pc(s)
The CCS811 Air Quality Breakout is a digital gas sensor solution that senses a wide range of Total Volatile Organic Compounds (TVOCs), including equivalent carbon dioxide (eCO2) and metal oxide (MOX) levels. VOCs are often categorized as pollutants and/or sensory irritants and can come...
− +
3.3V, 1A Step-Down Voltage Regulator D24V10F3
$14.50  
5 pc(s)
This D24V10F3 synchronous buck voltage regulator takes an input voltage of up to 36 V and efficiently reduces it to 3.3V while allowing for a maximum output current of 1 A. This regulator offers typical efficiencies between 80% and 90% and has a very low dropout, so it can be used with input...
− +
Protoboard, Strip, 10x24cm
$4.50  
2 pc(s)
Ideal for development and prototyping work, this protoboard is designed primarily for hard wiring of discrete components, typically in analogue circuits, but is equally useful where a number of common bus or signal lines are required. Size: 10 x 24cm, 1.5mm thick
− +
3-Blade Nylon Boat Propeller Set - 36mm Diameter
$2.00  
4 pc(s)
Small nylon propeller for port and starboard thruster. Featuring both left- and right-handed rotation. 3 blades and 36mm in diameter. It push fits directly onto our toy DC motor . Dimensions : Ø36 x 18.5mm Center bore：1.9 mm
− +
Non-Isolated Single Relay Module For 3V Controller
$6.50  
1 pc(s)
This single channel Relay Module is specially designed for low-voltage devices and works well with 3.3V power supply. It can be used to control the lighting, electrical and other equipments through the digital IO port. The module comes with on-board back EMF protection to eliminate the...
− +
Non-contact Liquid Level Sensor (PNP Output)
$19.95  
2 pc(s)
This non-contact liquid level sensor can be triggered when the liquid level fall below the sensor attached to the outside surface of a non-metal container. Unlike traditional liquid level sensors, it does not need to be immersed into liquid. So, in this way, liquid will not be contaminated...
− +
5 - 19
13 14 15 16 17 18 19 20 21 22 23 24 25 26 27
21 - 35

Recently Viewed