Light / Coloir

$19.99 $26.70  
13 pc(s)
This Wide Angle Ambient Light Sensor is based on BH1750 - a digital ambient light sensor with a 16 bit AD converter built-in which can directly output a digital value in lux (Lx) over a range of 1 - 65535 lx. This sensor is far more accurate and easier to use as compare to photocell which...

4 pc(s)
Basic breakout board for the TEMT6000 Ambient Light Sensor. Only what you need, nothing you don't. Sensor acts like a transistor - the greater the incoming light, the higher the analog voltage on the signal pin. Documents: Datasheet Wiring Example

4 pc(s)
The TCS34725 is probably the best color sensor on the market. It has a high sensitivity, wide dynamic range RGB and Clear light sensing elements. An integrated IR blocking filter minimizes the IR spectral component of the incoming light and allows color measurements to be made accurately. The...

$3.50 $5.50  
7 pc(s)
This Light sensor module uses a photocell (LDR - Light Dependent Resistor) to detect the light intensity of the environment. This module comes with a comparator so you will get either a logic LOW (when LDR is covered) or logic HIGH (when light is shining on LDR). Features:...

$1.20 $1.90  
20 pc(s)
The LDR Sensor Module is used to detect the presence of light / measuring the intensity of light. The output of the module goes LOW in the presence of light and it becomes HIGH in the absence of light. Features: Voltage: 3.3V~5V Analog output Dimensions: 21 x...

$1.00 $1.80  
203 pc(s)
This is a very small photocell. A photocell changes (also called a photodetector , CdS or photoconductive cell) resistance depending on the amount of light it is exposed to. These little sensors make great ambient light triggers (when light in the room turns on, do something)....

10 pc(s)
M5Stack is a robust, Arduino compatible, open source development kit with stackable modules, enabling rapid and high-quality IoT prototyping. This M5Stack Light Module uses photo cell to measure light intensity. The resistance of the photo cell depending on the amount of light it is...

2 pc(s)
If you’ve had ideas for a project that depends on the ability to sense different spectrums of visible light and react based on those measurements, the ISL29125 breakout board may be just what you need. The ISL29125 breakout board makes it very easy to sense and record the light intensity...

3 pc(s)
BH1750FVI is an digital Ambient Light Sensor IC for I2C bus interface. This IC is the most suitable to obtain the ambient light data for adjusting LCD and Keypad backlight power of Mobile phone. It is possible to detect wide range at High resolution. Features I2C bus Interface...