Post CB Phase 2: Shipping: Will ship ASAP. Pick-up: 11am to 4pm, Monday to Friday. Walk-in purchase: Not available.
If you're unable to reach us by phone, drop us an email.


1 2
This enclosure protects the Jetson Nano from things like rogue wires that might short it out while still allowing full access to the board! The enclosure provides slots to access the peripheral header, USB ports, Ethernet, SD card, HMDI, camera connector as well as cooling fan and vents to...

39 pc(s)
These inexpensive and reliable TT Gear Motors are an easy, low-cost way to get your projects moving. These gear motors require a voltage of 3-6VDC with a no load current of less than 150mA at 3V and possess a stall torque of at 6V, a gearbox ratio of 48:1, and it comes with 2 x 200mm...

23 pc(s)
This wifi module is a miniature USB wireless adapter with massive antenna that supports greater range and speed. It is fully complies with wireless 802.11b/g/n standards with data rate up to 300 Mbps when connecting with wireless 802.11n device. This Wifi module works well with the...

49 pc(s)
The USB Cable A to Pigtail provides a convenient method for hard wire a USB Type A connecting to a device or terminal block. One end of the cable is fitted with a strain relief USB Type A connector. The other end of the cable has stripped and tinned leads. This cable is commonly used to power...

738 pc(s)
USB 2.0 type A to micro USB 5-pin. This is a new, smaller connector for USB devices. Micro USB connectors are about half the height of mini USB. Micro USB is found on newer hand held devices like cell phones and portable media devices. Connector shape may vary slightly from image as our stock...

18 pc(s)
This USB to Micro USB Cable with switch is 1.5m long and is the perfect hard on/off power switch for your Raspberry Pi or any devices that has a MicroUSB port. Note : The data lines are not connected, so it's mostly just good for powering and charging devices. Dimensions: 1.5...
1 2