Browse by category

SGBotic Products
Arduino
BBC micro:bit
Raspberry Pi
STEAM
machine learning
Audio / MP3
Breakout Boards
Cables
Camera / Lenses
Components
Development Boards
E-Textiles
Instruments
LED / LCD
Power / Batteries
Programmers
Prototyping
RFID / NFC
Robotics / Hardware
Sensors
Tools
Wireless
School & Uni Packs

BBC micro:bit

1 2 3 4
Sort by Price: Low to High
12 Per Page
-38%
28mm Crocodile Clips (10 pcs)
$0.50 $0.80  
43 pc(s)
Pack of 10, 28mm Crocodile Clips. Excellent for fast prototyping where removable connections are essential. Features two side notches at the back of the clip for securing to leads and wires. Available as a pack of 10 clips. These miniature crocodile clips are perfect to use with...
− +
2 Way Spring Clamp Terminal Block (Pack of 3)
$0.95  
16 pc(s)
This terminal block is a spring clamp electrical connector where the individual stripped conductors are clamped down to the metal part by means of a spring. Compare to screw-type terminal block, this Spring Clamp Terminal Block gives you a constant connection. It always exerts the same force on...
− +
-11%
Educational Traffic Light Module
$1.20 $1.35  
3 pc(s)
The Educational Traffic Light Module is a low cost hardware module designed to allow users to take their first steps into interfacing microcontroller with the real world. It is designed to remove many of the common hurdles people are faced with when getting started using hardware with the...
− +
2 x AAA Battery Holder with JST Connector
$1.40  
1 pc(s)
This 2xAAA Battery Cage with JST connector is compatible with the BBC micro:bit. Supplied with colour coded power leads and a JST connector at the end, this battery cage is light and features a M3 mounting hole in the centre so it can be attached to the back of BBC micro:bit cases. The JST...
− +
2 x AAA Battery Holder w/Switch and JST Connector
$2.25  
Out-of-stock
This 2xAAA Battery Holder with Switch and JST Connector is compatible with the BBC micro:bit. Supplied with ~150mm colour coded power leads and a JST connector at the end, this battery holder is light and can be attached to the back of BBC micro:bit cases. This battery holder features a lid...
Out-of-stock
-40%
USB microB Cable - 1.5 meter
$3.00 $5.00  
1158 pc(s)
USB 2.0 type A to micro USB 5-pin. This is a new, smaller connector for USB devices. Micro USB connectors are about half the height of mini USB. Micro USB is found on newer hand held devices like cell phones and portable media devices. Connector shape may vary slightly from image as our stock...
− +
Vibration Motor Module
$3.25  
16 pc(s)
This small vibratory motor module is perfect for non-audible indicators. Use in any number of applications to indicate to the wearer when a status has changed. The on-board MOSFET driver allows the module to interface directly to microcontroller. Features : Operating voltage:...
− +
-50%
Breakout Board for BBC Micro:bit
$4.45 $8.90  
201 pc(s)
Unlock the potential of BBC Micro:bit with this assembled Breakout Board! This breakout board offers an easy way to connect additional circuits and hardware to the pins on the edge of the BBC micro:bit. It provides access to all of the BBC Micro:bit processor pins allowing a lot more extra...
− +
-50%
T-Expansion Board For Micro:Bit
$4.45 $8.90  
202 pc(s)
This T-Expansion For Micro:Bit is a small board that connects to the BBC micro:bit and breaks out all 19 GPIO, power and ground pin to breadboard-friendly arrangement and spacing. This board has all the pins labeled nicely so you can go forth and build circuits without keeping a pin-out...
− +
Miniature PIR Motion Sensor
$4.50  
6 pc(s)
This miniature PIR sensor is designed for motion detection. It uses pyroelectric sensor to detect motion by measuring changes in the infrared levels emitted by surrounding objects. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that...
− +
Audio Cable for BBC micro:bit
$4.50  
20 pc(s)
This is the perfect cable choice for those that want to output music or sound from BBC micro:bit to headphones or speakers. At one end of the cable are the black and red crocodile clips, which connect to the micro:bit GND and Pin 0 respectively. At the other end of the cable is a 3.5mm...
− +
Alligator Test Leads (Pack of 10) - Small
$4.80  
18 pc(s)
Alligator clips (or Crocodile clips, if you prefer) are likely to be the most useful thing on your workbench besides the workbench itself. Whether you're just trying to make a few quick connections to test your circuit or having trouble making your multimeter leads stay where you need them,...
− +
1 2 3 4