SGBotic Products

1 2
$16.95  
1 pc(s)
Looking for a liquid pump for your plant watering project? This Mini Submersible Liquid Pump Kit comes with a miniature pump with driver board and battery pack for 2xAA battery. The driver board is designed to operate between 3V to 5VDC supply. It works with PWM input, so you can increase or...

$10.95  
5 pc(s)
Introducing the new Circuit Explorer for BBC Micro:bit from SGBotic. This breakout board offers an easy way to connect additonal circuit and sensors to the micro:bit using the crocodile clips and copper tape. The back of the Circuit Explorer is made flat so that it can stick to any clean...

$19.95  
7 pc(s)
SGBotic Micro:bit Robot Board is designed for development of an autonomous obstacle avoidance robot or line following robot using BBC micro:bit . This Robot Board is capable of driving two DC motors. It has a dedicated port for HC-SR04 Ultrasonic Sensor and Line Follower Array . The...

$1.95  
23 pc(s)
This is a simple adaptor to provide an easy way to mount a HC-SR04 Ultrasonic Sensor to our 2WD Robot Chassis Kit . Fully assembled, no soldering is required. Notes: Copper standoff, nuts and screws are available separately.

$9.95  
31 pc(s)
This SGBotic Line Follower Array gives your robot the ability to follow a dark line on a white background or vice-versa. It has four IR sensors that have been configured to output digital signal. The array features visible LEDs which turn on when the sensors detect reflected IR light. You...

$9.50  
5 pc(s)
This fun little soldering kit enables you to make a 2-channel infra-red remote relay controller. The kit features a microcontroller that takes command from an infra-red receiver and controls 2 relays individually. Using an infra-red keypad, you will be able to turn on/off the relays....

$9.50  
2 pc(s)
This fun little soldering kit contains all the parts required to make a 2-channel infra-red remote motor controller. The kit features a microcontroller that takes command from an infra-red receiver and controls the speed of two motors individually. Using an infra-red keypad and four AA size...

$4.50  
4 pc(s)
This fun little soldering kit allows you to make a light activating security alarm. Using an LDR (Light dependent resistor) and an NPN transistor, the LED and buzzer will activate if light shinning on the LDR is above the pre-set threshold. The kit comes with a hardcopy construction guide....

$6.95  
4 pc(s)
This Wind Power Kit is designed to show students how alternative energy is created by harnessing the power produced by the wind. The kit has a high efficient generator that can produce useful electricity at low speed. It can generate sufficient electricity to light up a LED by blowing onto the...

$5.95  
7 pc(s)
This Wind Power Kit is designed to show students how alternative energy is created by harnessing the power produced by the wind. The kit has a high efficient generator that can produce useful electricity at low speed. It can generate sufficient electricity to light up a LED by blowing onto the...

$4.45 $8.90  
8 pc(s)
Unlock the potential of BBC Micro:bit with this assembled Breakout Board! This breakout board offers an easy way to connect additional circuits and hardware to the pins on the edge of the BBC micro:bit. It provides access to all of the BBC Micro:bit processor pins allowing a lot more extra...

$4.45 $8.90  
201 pc(s)
This T-Expansion For Micro:Bit is a small board that connects to the BBC micro:bit and breaks out all 19 GPIO, power and ground pin to breadboard-friendly arrangement and spacing. This board has all the pins labeled nicely so you can go forth and build circuits without keeping a pin-out...
1 2