SGBotic Products

1 2
$9.50  
2 pc(s)
This fun little soldering kit contains all the parts required to make a 2-channel infra-red remote motor controller. The kit features a microcontroller that takes command from an infra-red receiver and controls the speed of two motors individually. Using an infra-red keypad and four AA size...

$9.50  
5 pc(s)
This fun little soldering kit enables you to make a 2-channel infra-red remote relay controller. The kit features a microcontroller that takes command from an infra-red receiver and controls 2 relays individually. Using an infra-red keypad, you will be able to turn on/off the relays....

$4.45 $8.90  
8 pc(s)
Unlock the potential of BBC Micro:bit with this assembled Breakout Board! This breakout board offers an easy way to connect additional circuits and hardware to the pins on the edge of the BBC micro:bit. It provides access to all of the BBC Micro:bit processor pins allowing a lot more extra...

$10.95  
5 pc(s)
Introducing the new Circuit Explorer for BBC Micro:bit from SGBotic. This breakout board offers an easy way to connect additonal circuit and sensors to the micro:bit using the crocodile clips and copper tape. The back of the Circuit Explorer is made flat so that it can stick to any clean...

$1.95  
23 pc(s)
This is a simple adaptor to provide an easy way to mount a HC-SR04 Ultrasonic Sensor to our 2WD Robot Chassis Kit . Fully assembled, no soldering is required. Notes: Copper standoff, nuts and screws are available separately.

$9.95  
31 pc(s)
This SGBotic Line Follower Array gives your robot the ability to follow a dark line on a white background or vice-versa. It has four IR sensors that have been configured to output digital signal. The array features visible LEDs which turn on when the sensors detect reflected IR light. You...

$16.00  
1 pc(s)
SGBotic has created a series of micro:bit EduFun Mini Project Kits with an aim of making advance devices available to micro:bit inventors. Much efforts have been devoted to designing the MakCode blocks package to remove the complexity of using these devices, making it easier for inventors to...

$95.00  
1 pc(s)
SGBotic has created a series of Micro:Bit EduFun Mini Project Kits with an aim of making advance devices available to micro:bit inventors. Much efforts have been devoted to designing the MakeCode block packages to remove the complexity of using these devices, making it easier for inventors to...

$15.00  
13 pc(s)
SGBotic has created a series of Micro:Bit EduFun Mini Project Kits with an aim of making advance devices available to micro:bit inventors. Much efforts have been devoted to designing the MakeCode block packages to remove the complexity of using these devices, making it easier for inventors to...

$32.50  
2 pc(s)
This micro:bit Flex Sensor is specifically designed for micro:bit to detect flexing or bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface. This sensors are easy to use. It will vary its resistance depending on how much it...

$16.95  
1 pc(s)
Looking for a liquid pump for your plant watering project? This Mini Submersible Liquid Pump Kit comes with a miniature pump with driver board and battery pack for 2xAA battery. The driver board is designed to operate between 3V to 5VDC supply. It works with PWM input, so you can increase or...

$4.50  
4 pc(s)
This fun little soldering kit allows you to make a light activating security alarm. Using an LDR (Light dependent resistor) and an NPN transistor, the LED and buzzer will activate if light shinning on the LDR is above the pre-set threshold. The kit comes with a hardcopy construction guide....
1 2