SGBotic Products

1 2 3
$9.95  
Out-of-stock
When entering a carpark, a barrier bar will lift up for a car to pass through. When a train passes by, a barrier bar will come down to stop the cars from driving past. This Access Barrier Kit simulates such a barrier bar. The kit uses a servo motor to lift up/down the barrier bar and...
Out-of-stock

$32.50  
4 pc(s)
This micro:bit Flex Sensor is specifically designed for micro:bit to detect flexing or bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface. This sensors are easy to use. It will vary its resistance depending on how much it...

$14.95  
Out-of-stock
This hand-held crank generator produces up to 15 volts of DC electricity. The integrated PCB includes a full bridge rectifier to provide the same output polarity for either direction the hand crank is turning. In addition, other devices can be easily connected to the screw terminal.
Out-of-stock

$6.95  
5 pc(s)
This Wind Power Kit is designed to show students how alternative energy is created by harnessing the power produced by the wind. The kit has a high efficient generator that can produce useful electricity at low speed. It can generate sufficient electricity to light up a LED by blowing onto the...

$9.50  
2 pc(s)
This fun little soldering kit contains all the parts required to make a 2-channel infra-red remote motor controller. The kit features a microcontroller that takes command from an infra-red receiver and controls the speed of two motors individually. Using an infra-red keypad and four AA size...

$9.95  
31 pc(s)
This SGBotic Line Follower Array gives your robot the ability to follow a dark line on a white background or vice-versa. It has four IR sensors that have been configured to output digital signal. The array features visible LEDs which turn on when the sensors detect reflected IR light. You...

$4.50  
5 pc(s)
This fun little soldering kit allows you to make a light activating security alarm. Using an LDR (Light dependent resistor) and an NPN transistor, the LED and buzzer will activate if light shinning on the LDR is above the pre-set threshold. The kit comes with a hardcopy construction guide....

$7.45  
7 pc(s)
This Wind Power Kit is designed to show students how alternative energy is created by harnessing the power produced by the wind. The kit has a high efficient generator that can produce useful electricity at low speed. It can generate sufficient electricity to light up a LED by blowing onto the...

$1.95  
23 pc(s)
This is a simple adaptor to provide an easy way to mount a HC-SR04 Ultrasonic Sensor to our 2WD Robot Chassis Kit . Fully assembled, no soldering is required. Notes: Copper standoff, nuts and screws are available separately.

$4.45 $8.90  
202 pc(s)
This T-Expansion For Micro:Bit is a small board that connects to the BBC micro:bit and breaks out all 19 GPIO, power and ground pin to breadboard-friendly arrangement and spacing. This board has all the pins labeled nicely so you can go forth and build circuits without keeping a pin-out...

$16.95  
3 pc(s)
Looking for a liquid pump for your plant watering project? This Mini Submersible Liquid Pump Kit comes with a miniature pump with driver board and battery pack for 2xAA battery. The driver board is designed to operate between 3V to 5VDC supply. It works with PWM input, so you can increase or...

$37.50  
8 pc(s)
Looking for a device that allows you to control your robot and at the same time to see what the robot sees on your mobile phone? Look no further than this vRTCam from SGBotic. The vRTCam is designed for use with a mobile phone as remote controller with minimum setup. It is unique in a...
1 2 3