Development Boards

1 2
$6.20  
7 pc(s)
SPK HAT is a M5StackC compatible speaker. This HAT module features a PAM8303 mono audio amplifier. PAM8303 is a class D amplifier, able to deliver up to 3 Watts into 4 ohm impedance speakers. Since the amp is a class D, its very efficient (over 90% efficient when driving an 8Ω speaker at over...

$5.40  
10 pc(s)
M5Stack is a robust, Arduino compatible, open source development kit with stackable modules, enabling rapid and high-quality IoT prototyping. This M5Stack Angle Module is a rotary switch Unit, simply having a 10K potentiometer inside. This unit can be used for Continuous singal dialing...

$4.80  
9 pc(s)
M5Stack is a robust, Arduino compatible, open source development kit with stackable modules, enabling rapid and high-quality IoT prototyping. This M5Stack HUB Module is used for GROVE port expanding. It allows three I2C devices with unique address to connect to M5Stack Core. This HUB is...

$4.80  
10 pc(s)
PIR HAT is a M5StackC compatible PIR Motion Sensor. This is a pyroelectric sensor that detects motion by measuring changes in the infrared levels emitted by surrounding objects. When the motion is detected, the sensor will output HIGH and last for two seconds until the next detecting...

$4.30  
8 pc(s)
This ESP8266 WiFi Module Adapter allows easy interfacing of ESP8266 WiFi Module to Arduino Uno / Mega or any development board running on 5V logic. It features onboard LDO regulator to supply 3V to ESP8266 WiFi Module and logic level converter for both Tx and Rx pins. Note :...

$3.50  
9 pc(s)
M5Stack is a robust, Arduino compatible, open source development kit with stackable modules, enabling rapid and high-quality IoT prototyping. This M5Stack Light Module uses photo cell to measure light intensity. The resistance of the photo cell depending on the amount of light it is...

$2.95  
2 pc(s)
This ESP8266 WiFi Module Breakout Board allows you to take the dual row header of the ESP-01 and make it breadboard friendly. This board is fully assembled. NOTE : ESP8266 WiFi Module not included.

$2.60 $5.20  
1 pc(s)
This holder allows you to safely secure a IOIO development board and a self-adhesive breadboard in place to easily run jumper wires in between the two to form simple or complex prototyping circuits. Unlike it’s cousin, for the Arduino, this IOIO and breadboard holder has been made specifically...

$2.40  
30 pc(s)
This ESP8266 WiFi Module Breakout Board allows you to take the dual row header of the ESP-01 and make it breadboard friendly. This board comes with the header and decoupling capacitor presoldered, but requires you to solder on the male pins. NOTE : ESP8266 WiFi Module not included.
1 2