Browse by category

SGBotic Products
Arduino
BBC micro:bit
Raspberry Pi
STEAM
machine learning
Audio / MP3
Breakout Boards
Cables
Camera / Lenses
Components
Development Boards
E-Textiles
Instruments
LED / LCD
Power / Batteries
Programmers
Prototyping
RFID / NFC
Robotics / Hardware
Sensors
Tools
Wireless
School & Uni Packs

Robotics / Hardware

Roboteq
Robot Kits
MakerBeam
Motor Drivers
Motors / Servo
Mounts/Hubs
Others
Shafts
Pulleys and Belts
Pixhawk Autopilot
Wheels
1 2 3 4 5 6 7 8 9 10 11 12 13
7 - 16
Sort Alphabetically: A to Z
12 Per Page
Corner Cube Kit For MakerBeamXL - Clear
$25.70  
2 pc(s)
This Corner Cubes can join up to three MakerBeamXL in right angle. Corner Cubes are joined with a beam by the threaded beam ends. Each set contains 12 15mmx15mmx15mm cubes Note : Not compatible with 10mmx10mm MakerBeam.
− +
DELink 2 USB Link For Kangaroo PID Motion Controller
$35.00  
4 pc(s)
The DELink 2 USB Link is the perfect compliment to our Kangaroo x2 self-tuning PID motion controller. Coupled with the DEScribe software, you can upload / download settings or reset the Kangaroo to factory defaults. Utilizing the easy-to-use USB bus, changing the settings on your Kangaroo...
− +
Diaphragm Liquid Pump (6V to 12VDC)
$4.50  
10 pc(s)
Looking for a battery powered liquid pump? This non-submersible diaphragm liquid pump will operates between DC 6V to 12V. You can PWM the motor to speed up or slow down the flow rate. Works great with motor driver or a simple relay. Each diaphragm liquid pump comes with a pair of...
− +
Digital PWM Motor Speed Controller - 5A
$7.90  
2 pc(s)
This DC motor controller allows you to control both the speed and direction of a DC motor without sacrificing torque. It can provides up to a maximum continuous current of 5A to your DC motor or other DC load using a Pulse Width Modulated (PWM) with a Duty cycle fully adjustable from 10%-100%....
− +
DRV8825 Stepper Motor Driver Carrier, High Current
$26.95  
7 pc(s)
The DRV8825 stepper motor driver carrier is a breakout board for TI's DRV8825 microstepping bipolar stepper motor driver. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section...
− +
DRV8833 Dual Motor Driver Carrier
$18.00  
3 pc(s)
This tiny breakout board for TI’s DRV8833 dual motor driver can deliver 1.2 A per channel continuously (2 A peak) to a pair of DC motors. With an operating voltage range from 2.7 to 10.8 V and built-in protection against reverse-voltage, under-voltage, over-current, and...
− +
Dynamic Shunt Regulator (SR5K100V25R)
Contact us for details

 
 
The SR5K Shunt Regulator is a protection subsystem for dissipating the regenerative energy when braking or drastically reducing the speed of electric motors. During braking, the regenerative voltage can equal to or even exceed the supply voltage in some cases depending on the rotational inertia...
HerkuleX Interface Cable - 75mm
$1.60  
2 pc(s)
Interface cable for Hovis humanoid robot and HerkuleX Smart Servo. Length: 75mm
− +
HerkuleX Smart Servo DRS-0101 - 12kgf.cm
$55.00  
1 pc(s)
Download the Arduino library here ! This Dongbu's HerkuleX DRS-0101 servo is state of the art modular smart servos that support multi-drop TTL Full Duplex UART serial communications protocol with a maxium speed of 0.667Mbps. A single command can set the speed, position, LED lighting...
− +
High Torque Metal Gear Servo (270° Rotation)
$19.90  
3 pc(s)
This high-torque servo now comes with metal-gear for extra-high torque (10.5 kg/cm!) and reliability! It can rotate at approximately 270 degrees with a classic 500µS to 2500µS pulse. You can use any servo code, hardware or library to control these servos. Good for applications that require...
− +
L298 Dual Motor Driver Module 2A
$5.50  
3 pc(s)
This dual motor driver is based on the L298N heavy-duty dual H-bridge controller, which can be used to drive two DC motors at up to 2A each, with a voltage between 5 and 35V DC - or one stepper motor or 2 solenoids with ease. The driver has a nice heatsink to keep the L298N cool and all...
− +
Large Fan Blade - 170mm Diameter
$4.50  
6 pc(s)
Large fan blade for wind energy project. 170mm in diameter and has 1.9mm center bore for 2mm motor shaft. NOTE: Toy DC motor not included. Dimensions : Ø170 x 10mm Center bore：1.9 mm
− +
1 2 3 4 5 6 7 8 9 10 11 12 13
7 - 16