Browse by category

SGBotic Products
Arduino
BBC micro:bit
Raspberry Pi
STEAM
machine learning
Audio / MP3
Breakout Boards
Cables
Camera / Lenses
Components
Development Boards
E-Textiles
Instruments
LED / LCD
Power / Batteries
Programmers
Prototyping
RFID / NFC
Robotics / Hardware
Sensors
Tools
Wireless
School & Uni Packs

Components

1 2
Sort by Popularity: Low to High
24 Per Page
Slip Ring - 12 Wire (2A)
$18.95  
1 pc(s)
This is a 12 wire slip ring, a remarkably simple electromechanical assembly that allows electronic signals to be passed through its rotating innards. Commonly, you'd find slip rings in wind turbines, radar antennae, or anything else that requires continuous 360° rotation while maintaining an...
− +
W25Q64JVSSIQ SPI Flash - 64MBit (8MByte)
$1.95  
13 pc(s)
The W25Q64JV (64M-bit) Serial Flash memory provides a storage solution for systems with limited space, pins and power. They are ideal for storing voice, text and data. The device operates on 2.7V to 3.6V power supply with current consumption as low as 1µA for power-down. The W25Q64JV array...
− +
Coin Acceptor - Programmable 4 Coin Type
$59.95  
2 pc(s)
Your project may be free-as-in-speech, but that doesn't mean it has to be free-as-in-beer. This handy coin validator/acceptor module is just like the ones you've seen in arcades. This model has the cool ability to accept up to 4 different coins! For example, you can program it for 4...
− +
Transistor - PNP, 60V 200mA (2N3906)
$0.50  
143 pc(s)
These are very common, high quality BJT NPN transistors made by Fairchild Semiconductor. Documents : Datasheet
− +
-30%
Relay SPDT Sealed - 3V
$0.95 $1.35  
61 pc(s)
These are general purpose, Single Pole - Double Throw (SPDT) sealed relays. Use them to switch high voltage, and/or high current devices. This relay's coil has switch voltage of 3V at 120mA. The contacts are rated 10A at 120VAC, 10A at 30VDC. Features : 3V DC SPDT...
− +
Slip Ring - 6 Wire (2A)
$18.95  
5 pc(s)
This is a 6 wire slip ring, a remarkably simple electromechanical assembly that allows electronic signals to be passed through its rotating innards. Commonly, you'd find slip rings in wind turbines, radar antennae, or anything else that requires continuous 360° rotation while maintaining an...
− +
microSD USB Reader
$3.50  
5 pc(s)
This is an awesome little microSD USB reader. Just slide your microSD card into the inside of the USB connector, then stick this into a USB port and the card's contents will pop up on your computer. Very sneaky - we love it! This little guy is great for pulling data logs off microSD media. This...
− +
Split Ferrite Cable Core For RFI / EMI Noise Suppression
$1.80  
3 pc(s)
This easy-to-use split ferrite core provides a cost-effective means to reduce the electromagnetic interference from being induced in or radiated from data and power cables. The special designed plastic housing allows the ferrite sleeve to use with a variety of cable diameters from 3 to 5mm...
− +
Transistor - NPN, 60V 200mA (2N3904)
$0.50  
111 pc(s)
These are very common, high quality BJT NPN transistors made by ON Semiconductor. Documents : Datasheet
− +
NPN Transistors - 45V 800mA (BC337)
$0.50  
677 pc(s)
This BC337 is a drop-in replacement for the 2N2222 Transistor This is the BC337, an NPN silicon BJT (Bipolar Junction Transistor). This little transistor can help in your project by being used to help drive large loads or amplifying or switching applications. The BC337 is specifically rated...
− +
NPN Transistors - 2N2222A
$0.50  
30 pc(s)
2N2222A is designed for high speed switching application at collector current up to 600mA, and feature useful current gain over a wide range of collector current, low leakage currents and low saturation voltage.
− +
MicroSD Card Adapter
$0.20  
33 pc(s)
The micro SD card adapter looks like a regular-sized SD card with a slot in it for the microSD card. It allows you to transfer data between your device and a computer.
− +
Voltage Regulator - 3.3V
$2.75  
20 pc(s)
This is the basic LD1117V33 voltage regulator, a low drop positive regulator with a 3.3V fixed output voltage. This fixed regulator provides a great amount of stability and protection for your project and with its on chip trimming this regulator is able to reach an output voltage tolerance...
− +
Passive Piezo Buzzer w/Leads -13mm
$2.90  
3 pc(s)
This is a small 13mm round passive buzzer that operates around the audible 4kHz range. We drove it directly from a 3v to 5V Arduino or micro:bit to generate simple melody. The buzzer leads are terminated with male pin. Note : This passive buzzer requires a square wave (PWM) signal to...
− +
-30%
microSD Card - 64GB (Class 10, UHS-I )
$14.00 $20.00  
9 pc(s)
This is a class 10 64GB microSD memory card, perfect for housing operating systems for single board computers and a multitude of other information. Since this is a class 10 UHS-I microSD it is capable of transferring data at speeds up to 100MB/s allowing it to have a noticeable increase in...
− +
-50%
3DR Buzzer for PX4 / Pixhawk
$2.25 $4.50  
52 pc(s)
This buzzer is used with Pixhawk and PX4 autopilot to annunciate status tones. The buzzer includes a two-position DF14 connector on one side that plugs directly into the Pixhawk or PX4 FMU board. Wire length: ~190mm
− +
Aluminum Heatsink Self-adhesive - 11mmx11mm
$0.50  
8 pc(s)
This tiny little aluminium heatsink is a perfect solution for cooling off small surface-mount components such as CPUs on Raspberry Pi or stepper motor driver. The heatsink includes thermal adhesive tape for better heat dissipation. The installation is simple, what you need to do is to remove...
− +
-50%
Thermally Conductive Adhesive
$0.75 $1.50  
20 pc(s)
This thermally conductive adhesive is used widely for heat sinks without fixed fastener, such as on voltage regulator, MOSFET, high power LED and so on. It allows heat to be transferred from IC to the heat sinks, effectively protects IC from thermal impacts, Features : Heat conductivity:...
− +
Active Piezo Buzzer 3-24VDC Pulse Tone
$1.70  
5 pc(s)
Loud sounders that may be powered with a voltage of anywhere from 3.0 to 24VDC. It has additional circuitry in it which makes it easier to use but limits the buzzer to only making one type of a sound (tone). It only requires DC power source for the tone to be generated. This buzzer is...
− +
Thermoelectric Cooler - 40x40mm
$3.90  
3 pc(s)
Thermoelectric coolers (TEC or Peltier) create a temperature differential on each side. One side gets hot and the other side gets cool. Therefore, they can be used to either warm something up or cool something down, depending on which side you use. The Thermal Tape listed below works very...
− +
MCP3002 - 2-Channel 10-Bit ADC With SPI Interface
$3.50  
39 pc(s)
The MCP3002 has a 10-bit analog to digital converter (ADC) with a simple to use SPI interface. Use this IC if your microcontroller does not have an ADC or have enough ADC lines. A great chip when you need to add additional ADC lines. Features : 2.7V to 5.5V supply 2 Channels...
− +
Active Piezo Buzzer 3-24VDC Continuous Tone
$1.70  
Out-of-stock
Loud sounders that may be powered with a voltage of anywhere from 3.0 to 24VDC. It has additional circuitry in it which makes it easier to use but limits the buzzer to only making one type of a sound (tone). It only requires DC power source for the tone to be generated. This buzzer is...
Out-of-stock
Mini USB Microphone
$7.95  
2 pc(s)
This plug-and-play Mini USB Microphone needs no driver, and its USB interface means you can use it with any computer, laptop, SBC, etc! Works great with a Raspberry Pi computer, but you can also use it with any other computer you want to record audio on. Simply plug it right in and...
− +
MCP3008 - 8-Channel 10-Bit ADC With SPI Interface
$4.50  
5 pc(s)
The MCP3008 has a 8-Channel 10-bit analog to digital converter (ADC) with a simple to use SPI interface. Use this IC if your microcontroller does not have an ADC or have enough ADC lines. A great chip when you need to add additional ADC lines. Features : 2.7V to 5.5V supply...
− +
1 2