Compass/Magneto

The CMPS09 module is a tilt compensated compass. Employing a 3-axis magnetometer and a 3-axis accelerometer and a powerful 16-bit processor, the CMPS09 has... More

The OS5000-S is an extremely small form factor (1x1” square) three axis, tilt compensated digital compass. The flexible design uses a simple RS232... More

The OS5000-US is an extremely small form factor (1x1” square) three axis, tilt compensated digital compass. The OS5000-US combines a small size with... More

The OS4000-T has an extremely small form factor (0.6x0.6” square), even smaller than the OS5000-S . This tiny module contains a high resolution... More

This board conveniently breaks out the RX, TX and power pins of the tilt compensated OS4000-T compass module. The 0.05" spaced pins of the OS4000-T are... More

This is a breakout board for Honeywell's HMC5843, a 3-axis digital compass. Communication with the HMC5843 is simple and all done through an I2C interface.... More

This is the latest IC module in the compass arena from Honeywell. The HMC6343 has three axis of magneto, three axis of accelerometer, and a PIC core... More

This is a very simple breakout board for the popular HMC6352. If you need simple, clean, degree resolution compass heading, this is the way to go.... More

This is a very basic full breakout board for the HMC1052L Dual Axis Magnetic Sensor. This 14-pin board brings every pin on the HMC1052L sensor out to... More

This is a simple evaluation board for the Honeywell's HMC1052L magnetic sensor. The MOSFET reset and amplifier circuitry are all on board. All you... More

The ATS177 is an integrated Hall effect latched sensor. That's nice but what does it do? Holding a magnet near the sensor will cause the output pin to... More

This compass module has been specifically designed for use in robots as an aid to navigation. The aim was to produce a unique number to represent the... More