IMU

 This is the latest wireless accelerometer from SparkFun. The WiTilt v3 incorporates many new features including LiPo battery, built-in charger,... More

The Arduino-compatible IMU is a project by Chris Anderson and Jordi Muñoz to create an AHRS (attitude heading reference system) for UAV... More

The 9DOF Razor IMU incorporates four sensors - an LY530AL (single-axis gyro), LPR530AL (dual-axis gyro), ADXL345 (triple-axis... More

There's a lot of punch packed into this little IMU. The 6DOF Razor makes use of ST's LPR530AL (pitch and roll) and LY530ALH (yaw) gyros, as well as the... More

The Inertia Measurement Unit Combo Board is now available! This small PCB board incorporates an Analog MEMs gyroscope and accelerometer in a tight... More

The Inertia Measurement Unit Combo Board is now available! This small PCB board incorporates an Analog MEMs gyroscope and accelerometer in a tight... More

The Inertia Measurement Unit Combo Board is now available! This small PCB board incorporates an Analog MEMs gyroscope and accelerometer in a tight... More

This Inertia Measurement Unit Combo Board incorporates the IDG500 dual-axis gyroscope and Analog Devices triple axis ADXL335 accelerometer in a tight... More

The 6DOF Atomic is a stripped-down IMU, designed to give good performance at a low price. The unit can run as a hard-wired UART interface (0-3.3V,... More

The 6DOF v4 Inertial Measurement Unit (IMU) is the latest Sparkfun IMU offering. The v4 provides 3 axes of acceleration data, 3 axes of gyroscopic data,... More

This is the 6DOF v4 controller board. It can be used as a drop-in replacement for a damaged 6DOF v4, or it can be used as a control system / development... More

This is the 6DOF v4 sensor board. It can be used as a drop-in replacement for a damaged 6DOF v4, or it can be used as a stand-alone sensor array.... More