Loading...
Home>Breakout Boards

Breakout Boards

View as:  List
Sort by:  Default
OpAmp Breakout

SKU: BOB-00206

$7.30
Sparkfun Electronics
This is a simple Op Amp breakout board, set up as a 2-stage amplifier with a gain of 100 (gain of 10 for each stage). The on-board trim pot sets the signal... More
5 Unit(s)
Logic Level Converter

SKU: BOB-00209

$3.50
Sparkfun Electronics
If you've ever tried to connect a 3.3V device to a 5V system, you know what a challenge it can be. The SparkFun logic level converter is a small device... More
18 Unit(s)
Breakout Board for Electret Microphone

SKU: BOB-00214

$9.60
Sparkfun Electronics
Ready to add audio to your next project? This small breakout board couples a small electret microphone with a 100x opamp to amplify the sounds of voice,... More
12 Unit(s)
RS232 Shifter SMD Without DB9

SKU: BOB-00223

$14.00
Sparkfun Electronics
The smallest and easiest to use serial conversion circuit on the market! This board has one purpose in life - to convert RS232 to TTL and vice versa (TX... More
17 Unit(s)
Breakout Board for RJ45

SKU: BOB-00266

$2.30
Sparkfun Electronics
This is a small PCB that brings out the pins of the RJ45 connector to an in-line 0.1" footprint. Use with break-away headers for breakboarding or create... More
10 Unit(s)
MiniDIN 6-Pin Connector Breakout

SKU: BOB-00268

$1.10
Sparkfun Electronics
This is a bread board friendly breakout board for the MiniDIN-6 connector. Board brings out all 6 pins to a 0.1" spaced connector. Use this breakout for... More
1 Unit(s)
Mic Preamp

SKU: BOB-1019

$3.57
Sparkfun Electronics
This is a simple microphone preamplifier circuit for a wide range of microphone types, with good pre-amplification to attach to your larger stereo... More
Breakout Board for FT232RL USB to Serial

SKU: BOB-00346

$21.90
Sparkfun Electronics
Basic breakout board for FTDI's popular USB to UART IC. Now with internal oscillator and EEPROM, the FT232RL is an impressive IC! VCCIO is now tied to... More
2 Unit(s)
Real Time Clock Module

SKU: BOB-00366

$20.30
Sparkfun Electronics
This a custom designed module for the DS1307 Real Time Clock. The module comes fully assembled and pre-programmed with the current time (i.e. MST). The... More
13 Unit(s)
Opto-isolator Breakout

SKU: BOB-00402

$6.90
Sparkfun Electronics
This is a board designed for opto-isolation . This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or... More
3 Unit(s)
Breakout Board for Thumb Joystick

SKU: BOB-00421

$2.80
Sparkfun Electronics
This is the breakout board for the thumb joystick . Pins are broken out to a 0.1" header and includes 4 mounting holes in the corners.... More
3 Unit(s)
Breakout Board for VS1103 MIDI Decoder

SKU: BOB-1028

$28.90
Sparkfun Electronics
The VS1103b is a single-chip MIDI/ADPCM/WAV audio decoder and ADPCM encoder that can handle up to three simultaneous audio streams. It can also act as a... More
Breakout Board for CP2103 USB to Serial w/ GPIOs

SKU: BOB-00442

$31.80
Sparkfun Electronics
Basic breakout board for the new Silicon Laboratories' CP2103 USB to Serial IC. Features: Implements full v2.0 USB protocol... More
2 Unit(s)
RS232 Shifter SMD

SKU: BOB-00461

$18.90
Sparkfun Electronics
The smallest and easiest to use serial conversion circuit on the market! This board has one purpose in life - to convert RS232 to TTL and vice versa (TX... More
13 Unit(s)
Breakout Board for SIM Cards

SKU: BOB-00462

$18.00
Sparkfun Electronics
This is a full 8-pin breakout for the SIM socket allowing direct access to SIM communication. Note:  This breakout board was originally designed... More
1 Unit(s)
Blackberry Trackballer Breakout

SKU: B0B-00476

$20.50
Sparkfun Electronics
This is a breakout board for the Blackberry Trackball . The four spindles on the trackball have a tiny circular magnet the end; each of these are... More
1 Unit(s)
PCM1803A Analog to Digital Stereo Converter Breakout

SKU: BOB-00557

$15.65
Sparkfun Electronics
The PCM1803A is a high-performance, low-cost, 24-bit stereo analog-to-digital converter that can sample as high as 96k. The PCM1803A is a great choice for... More
3 Unit(s)
L298N Breakout board

SKU: BOB-00580

$3.50
Sparkfun Electronics
This is a breakout board for the L298N full-bridge dual motor driver; which comes in a staggered, Multiwatt package. All pins of the L298N are... More
2 Unit(s)
Breakout for AD9835 Signal Generator

SKU: BOB-00632

$42.20
Sparkfun Electronics
This is a breakout board for the AD9835 signal generator chip from Analog devices. The AD9835 allows the user to make sine waves from 1Hz up to 25MHz with... More
I2C/SMBus Voltage Traslator (I2C Level Shifter)

SKU: BOB-00707

$19.90
This great tiny board will allow to interface slave 3.3V I2C devices like magnetometers and pressure sensors with master 5V devices like AVR/PIC... More
5 Unit(s)
Breakout Board for ADMP401 MEMS Microphone

SKU: BOB-00752

$15.50
This tiny breakout board features the ADMP401 MEMs microphone. One of the key advantages to this breakout and microphone is the bottom ported input. This... More
5 Unit(s)
RS-485 Breakout

SKU: BOB-00914

$13.90
Sparkfun Electronics
This is a breakout board for the SP3485 RS-485 transceiver IC, which will convert a UART serial stream to RS-485. The SP3485 is a half-duplex transceiver,... More
5 Unit(s)
Breakout Board for USB microB

SKU: BOB-00920

$2.30
This simple board breaks out a micro-B USB connector's VCC, GND, D- and D+ pins to a 0.1" pitch header. If you want to add the increasingly popular micro-B... More
7 Unit(s)
RPI-1031 Tilt-a-Whirl Breakout

SKU: BOB-01035

$9.90
The RPI-1031 tilt sensor is capable of sensing a change in orientation in four different directions: forward, back, left or right. This breakout board... More
3 Unit(s)
PCA9306 Level Translator Breakout

SKU: BOB-01072

$10.50
This is a breakout board for the PCA9306 dual bidirectional voltage-level translator. Because different parts sometimes use different voltage levels to... More
13 Unit(s)
Rotary Encoder Breakout - Illuminated (Red/Green)

SKU: BOB-01168

$5.90
This is a breakout board for the illuminated rotary encoder . It breaks out all of the pins to standard, breadboard friendly, 0.1" headers. Simply... More
4 Unit(s)
LED RingCoder Breakout - RGB

SKU: BOB-01200

$9.90
This breakout board gives you a pretty slick interface for rotary input. Since rotary encoders turn continuously it can be difficult to imagine where in... More
4 Unit(s)
Breakout Board for microSD Transflash

SKU: BOB-00082

$12.00
Sparkfun Electronics
Breakout board for the microSD socket that is not much bigger than your fingernail. Compatible with the SPI interface found on any SD card, this tiny form... More
2 Unit(s)
Breakout Board for USB miniB

SKU: BOB-00084

$2.30
Sparkfun Electronics
This new version now has all 5 pins broken out on the connector. We have no idea what USB device you are hooking up to, but if you need to add a... More
3 Unit(s)
Breakout Board for XBee Module

SKU: BOB-00066

$4.00
Sparkfun Electronics
This is a simple breakout board for the popular XBee product from Maxstream. This board breakouts out all 20 pins of the XBee to a 0.1" standard spacing... More
16 Unit(s)
SOIC to DIP Adapter 20-Pin

SKU: BOB-00087

$5.40
Sparkfun Electronics
This is a low-cost basic SOIC break out boards. These are custom PCB boards that interface standard SOIC devices to standard 0.1" (2.54mm) headers.... More
17 Unit(s)
SOIC to DIP Adapter 28-Pin

SKU: BOB-00088

$4.70
Sparkfun Electronics
Low-cost basic SOIC break out boards. These are custom PCB boards that interface standard SOIC devices to standard .1" (2.54mm) headers. 28-SOIC:... More
17 Unit(s)
SOIC to DIP Adapter 8-Pin

SKU: BOB-00089

$3.50
Sparkfun Electronics
Your basic SOIC break out boards. What's the difference? The 8 Pin board is TINY. And you can't beat the price! These are custom PCB boards that... More
5 Unit(s)
SSOP to DIP Adapter 16-Pin

SKU: BOB-00090

$3.50
Sparkfun Electronics
8, 16, 20, and 28-Pin SSOP to DIP break out boards. The footprint was rotated to accommodate different width SSOP devices and can be used with any pin... More
8 Unit(s)
SSOP to DIP Adapter 20-Pin

SKU: BOB-00091

$4.70
Sparkfun Electronics
8, 16, 20, and 28-Pin SSOP to DIP break out boards. The footprint was rotated to accommodate different width SSOP devices and can be used with any pin... More
20 Unit(s)
SSOP to DIP Adapter 28-Pin

SKU: BOB-1010

$4.70
Sparkfun Electronics
8, 16, 20, and 28-Pin SSOP to DIP break out boards. The footprint was rotated to accommodate different width SSOP devices and can be used with any pin... More
3 Unit(s)
SSOP to DIP Adapter 8-Pin

SKU: BOB-00094

$3.50
Sparkfun Electronics
8, 16, 20, and 28-Pin SSOP to DIP break out boards. The footprint was rotated to accommodate different width SSOP devices and can be used with any pin... More
20 Unit(s)
SOT23 to DIP Adapter

SKU: BOB-00188

$1.30
Sparkfun Electronics
6 pin SOT-23 to DIP adaptor. Created to take SOT23 of various pin sizes breakout to DIP. This will work with 3-pin MOSFETs, BJTs, Voltage Regulators... More
4 Unit(s)
Breakout Board for SD-MMC Card

SKU: BOB-01215

$13.50
Sparkfun Electronics
With SD and MMC memory prices dropping, the time is right for mass storage and datalogging. This breakout board will allow you to breakout the SD/MMC... More

Categories

 

Information

 

My account

Track my order(s):